Rain Drain Installation instructions

Thank you for your purchase and welcome to the All Systems Go Offroad family!!


ASG Offroad Rain Drain Installation Instructions
 

*Read all steps prior to installation*
 

  1. Prepare the camper’s lower t-track (located on the bottom of the camper) for the mounting nuts by wiping off any dust/debris.

  2. Unscrew the track t-nuts a few turns and orient them horizontally (parallel to the track) to allow them to be inserted in the track.

  3. Align and insert all t-nuts to their respective locations on the track.

  4. Tighten down all three t-nuts to the camper (snug/finger tight is good with an allen wrench...no need to kill it, use a socket wrench or power tool!…this will avoid damaging the Rain Drain, hardware, or t-track).  Make sure that the t-nuts are oriented correctly to grab the t-track (this may take a moment to do as they can be difficult).

  5. This is the most important part…step back, admire your new Rain Drains, and banish the waterfall back to its rightful place in your rig’s factory rain channel. Now you’re ready for your next adventure as All Systems are Go for Offroad!!!

 

Rev. 24.03.04