Camper Leash Instructions
Thank you for your purchase and welcome to the All Systems Go Offroad family!!
ASG Offroad Camper Leash Installation Instructions
*Read all steps including sub-sections prior to installation*
- Prepare the campers top t-track for the mounting blocks by wiping off any dust/debris.
-
Unscrew the track t-nuts a few turns to allow them to be inserted in the track.
-
Place the mounting blocks in the desired location on the t-track, with the narrow hook point towards the ground and tighten them down (no need to kill it to avoid damaging the mounting block, hardware, or t-track).
-
For example, I positioned mine directly above the rear hatch hinges.
-
For example, I positioned mine directly above the rear hatch hinges.
-
Attach the leash to the mounting blocks.
-
Deploy the camper.
-
Take up the slack in the leash while deploying to prevent snagging on anything.
-
Take up the slack in the leash while deploying to prevent snagging on anything.
-
Adjust the leash to your desired length by feeding the leash through the tri-glide.
-
When “closing up shop,” take up leash slack and ease into closing the camper.
-
This will avoid any undue stress on the mounting blocks, camper hinge, and struts.
-
This will avoid any undue stress on the mounting blocks, camper hinge, and struts.
- This is the most important part…step back and admire your new camper leash, and prepare for your next adventure as All Systems are Go for Offroad!
Rev. 24.02.19